Refinishing Hardwood Floors – Sanding

Refinishing a hardwood floor is a fairly easy way to add beauty and value to any home. It can even be a real ego raise for the undertake it yourselfer. Doing it yourself could save you money if you follow these easy steps. Athena Contracts Flooring

The most important factor to consider when refinishing is a hardwood floor is cleanliness. You want to be sure the floor is free of any debris. Debris can get caught in the sander and damage the floor. Small jagged pebbles are the most detrimental. Sometimes it isn’t possible to see the harm until once you apply your finish coats, and then it’s past too far. 

The baseboards are also another factor you must consider. In the event that you are confident with your skills, you can gently remove them with a tiny flat-bar and a hammer. Invest some time. The idea is to remove and replace, not remove and then drive to the hardware store because you broke the boards. You can leave the baseboards in place whether it just isn’t practical to remove them. If you choose to leave the baseboards, I actually recommend that you keep them safe with group of painters tape. The energy sander will damage them if you are not careful.

In the event that the floor is clean, and the baseboards have been removed or safeguarded sufficiently, you can commence to sand. I recommend renting an orbital sander with a rectangular face. (Be careful when carrying it to and from your home and ensure you have someone help when lifting the sander. ) Start with 80 determination sand paper. Slowly move the sander smoothly over the floor. Make sure you are sanding seite an seite with the joints in the ground. Try not to sand perpendicular to the joints, as this type of sanding can damage the wood and cause the finish to look less than perfect. The number of moves it will take to remove the old finish will change from floor to floor. Be deliberate. Remove all the old finish before you move to a smaller girt sand newspaper.

Now that you are done sanding with the 80 grit sand newspaper, you will want to sweep or vacuum the floor. This removes any large wood particles or debris which may have been dislodged. Once washed, sand the floor in exactly the same fashion using 120 grit yellow sand paper. You will learn the a hundred and twenty grit sand paper sands very efficiently. This is because you are no longer sanding through the old finish and the sand paper is immediately on the face of the wood. Try to be smooth and liquid as you move the sander. In case you pause or stop, you will over sand and create low spots in the floor.

You will know when the sanding is complete by the look and feel of the floor. Visually you will not see any shinny or glossy areas. The floor will have an easy and dry feel to it. Take you time to crawl around and closely inspect the floor. If you discover any areas that do not meet your standards, carefully sand them again. Because you sand over the imperfections, make certain that you do not maintain the sander in a single place for a prolonged time period. Instead, make passes above the area seeking to be sanded; brief ones first, accompanied by gradually longer ones. This system is called feathering and will prevent over sanding your floor in any one area.

After your final inspection of the ground is complete, you will want to clean again. Intentionally vacuum or sweep up all the debris. Then simply, by using a slightly damp natural cotton towel, wipe over the complete floor surface. While you are cleaning, keep the towel in a single orientation against the floor. Usually do not opt for it up. The goal is to capture any small debris left lurking behind on the front face from the towel. You will notice that the ground wicks some of the water from the hand towel. This is normal and may not affect your last finish as long as you allow it to dry.